|
|
|
|
Aviom AN-16/I V.2 16-Channel Line-Level Input Module
- Sixteen balanced audio inputs (1/4-in TRS connectors)
- Sixteen balanced Thru connectors (TRS)
- A-Net In with four-position slot range selector switch
- Stereo Link switches for each channel pair
- Four-position gain switches (+22, +4, 0, -10dB)
- Signal present and clip LEDs per channel
The Aviom AN-16/i v.2 Input Module is used to connect up to 16 balanced line-level inputs from a console’s direct outputs, insert points, aux sends, and/or submixes to a personal mixing system or digital snake. When used alone, one AN-16/i v.2 can generate a single 16-channel A-Net signal.
The A-Net In on the AN-16/i v.2 allows multiple Pro16 input devices (including console cards, AN-16/i-M, AV-M8, and the original AN-16/i) to be connected together to generate the higher channel count Pro16e™ version of A-Net used by the A360 Personal Mixer and A320 Personal Mixer.
Compatibility Note: The Pro16e A-Net output of the AN-16/i v.2 is not compatible with the original A-16 Personal Mixer, AV-P2 Output Module, AN-16/o v.3 Output Module, and AN-16/o v.4 Output Modules with serial numbers 51162 and lower.
SPECIFICATIONS
- Audio Inputs: 16, balanced line-level, 1/4-inch TRS connector
-
Inputs Tip: Audio +; Ring: Audio -; Sleeve: Ground
-
TRS Thru: Impedance matched output
-
Analog to Digital Conversion: 48kHz sample rate, 24 bit
-
Frequency Response: 4Hz-22kHz
-
A- Net In: One Category 5 (RJ45 connector)
-
Four-position slot range selector switch for use with Pro16e A-Net
-
A-Net Out: One Category 5 (RJ45 connector)
-
Gain Settings: Four-position switch, -10dBv, 0dBu, +4dBu, and +22dBu
-
Channel LED Indicators: Signal Present and Clip, per channel
-
Line Inputs Impedance: 48k ohms
-
Metering: LEDs; green: Signal Present, red: Clip; per channel
-
Stereo Operation: Stereo Link, per channel pair;
-
Two-position switch (Normal, Link)
-
Maximum Input Level: +22dBu
-
Input Impedance: 17.8k ohm
-
Freq. Response: 4Hz-22kHz +0.2dB/-3dB
-
THD +N: < 0.003%
-
Crosstalk: -90dB
-
Bit Error Rate (BER): 10(-12)
-
Signal to Noise (unweighted): 90dB typical, A/D to D/A
-
Measured from AN-16/i to AN-16/o Output Module
-
Digital Outputs A-Net: 1; RJ45 connector
-
Pro16e A-Net: Use unshielded Cat-5e UTP (or better) cable
-
Latency <0.880 msec (measured from analog input to analog output)
-
Power Supply: External, DC, universal switching type
-
Input Voltage: 100-240 volts, 50/60Hz, 30VA
-
Output Voltage: 18-24 VDC, 0.5 amp
-
Plug Size: 2 mm
-
Power: 18-24 VDC, 500mA
-
Dimensions: 19" (482.6 mm) wide x 5.75" (146 mm) deep;
-
1U high
-
Weight: 6.8 lb (3.08 kg)
For more information on this or any other Aviom product, visit www.aviom.com.
|
|
|
|
|
|
|